vyberun manual HomeReleasesSupport Get vyberun ✕
Manual › Claude Code

Subagents and skills

Follow a Claude's own agents as they work, and give an agent skills of its own.

Subagents in the sidebar

A Claude can run agents of its own, defined in its project's .claude/agents. They run inside that one Claude tab, with no extra terminals. While they work, vyberun gives each a line under the Claude tab in the sidebar: what it's doing now, and for how long. A finished one says done for a few minutes afterwards.

Following one

Click a subagent's line to follow its work beside the terminal: what it was asked, the files it read and changed, the commands it ran and what came back. The panel is read only: nothing is sent to the agent. Esc or ✕ closes it.

New and stuck

  • new: it finished while you were elsewhere. If vyberun isn't in front and notifications for long commands are on, Windows tells you too.
  • stuck? in amber: it keeps hitting the same wall, such as commands blocked by a hook, the same command again and again, errors in a row, or a long silence. Its panel says why.

Skills

A saved agent can bring skills: instructions Claude Code loads for that tab alone.

  1. Open Settings ▸ Agents and edit the saved agent.
  2. Add .md or .zip files…: a .md is a skill itself, a .zip is a skill's folder.
  3. Start the agent on a card (⋯ ▸ Start agent). Its skills are there in that tab.

Edit a skill's file any time, in any editor: an agent started afterwards reads the new version.

vyberun manual · applies to 0.1.11Report a mistake